DT6228
From the capaNCDT DT62xx controllers series
capaNCDT DT62xx controllers: measurement controllers by Micro-Epsilon for capacitive.
- Number of measurement channels
- 4
Technical specification
Every engineering figure, laid out to scan quickly
| Linearity (% FSO) | 0.05 % |
|---|---|
| Interfaces | Ethernet |
| Output update rate | 3.906 kHz |
| Number of measurement channels | 4 |
| Storage temperature | -10–75 °C |
| Operating temperature | 10–60 °C |
| Protection class (DIN EN 60529) | IP40 |
| Frequency response cutoff Maximum rate with a compatible controller | 1 kHz (−3 dB) |
| Channels | Up to 4 inputs; one module per sensor head |
| Analog output | 0–10 V / 4–20 mA; select output path |
| Static resolution (% FSO) | 0.0005 % FSO (RMS; 2 Hz; end-of-range reference) |
| Dynamic resolution (% FSO) | 0.01 % FSO (RMS; 1 kHz) |
| Module slots | 4 |
Values by configuration
These values differ with the controller or interface the sensor is used with. Each row applies to one configuration only; check the configuration in the system builder or with us.
| Dimension (drawing reference) | 75 mm |
|---|---|
| Dimension (drawing reference) | 100 mm |
| Dimension (drawing reference) | 125 mm |
| Dimension (drawing reference) | 150 mm |
| Dimension (drawing reference) | 90 mm |
Compatible system components
Accessories
-
DL6228
- Measuring rate
- Not specified
- Communication
- Not specified
- Inputs
- 1
- Signal type
- Not specified
- Bandwidth (−3 dB)
- 1 kHz
The industries we serve
Frequently asked questions
Answers to the most common questions about our products and services
DT6228 uses DL6228 demodulators. The manufacturer recommends this combination for CSE-x/HT high-temperature sensors and lists general compatibility with all capaNCDT sensors. The HT recommendation is not a restriction to HT sensors only.
DT6228 lists Ethernet. Select the basic-module model for the required communication, and the number of DL6228 modules for the required measuring channels, up to 4 channels. A supported channel is not necessarily an installed channel.
The table lists a maximum digital measuring rate of 3.906 kHz and an analogue bandwidth of 1 kHz, switchable to 20 Hz. These are separate parameters; filter and bandwidth selection also affect noise and resolution conditions.
The listed linearity below ±0.05% FSO applies to the controller only; add the sensor contribution. IP40 is the controller protection class, not a temperature or ingress rating for the sensor head, cable or complete assembly.
Get a quote or advice
Tell us what you need and an engineer will come back to you.