Skip to content

TYPE 4371

HBK’s Type 4371 is a uniaxial charge accelerometer with a side connector. HBK positions it for vibration measurements that include higher frequencies. Its nominal sensitivity is 9.8 pC/g. Use a suitable charge amplifier and configure the channel for the individual calibration and mounting arrangement.

Visit the HBK site (opens in a new tab)

Models in the series

One column per model: what differs between the models of the series.

Models of TYPE 4371 compared by parameter
Parameter -4371— -4371--- -4371-V– -4371-V--
Repeatability reference HBK does not publish a separate scalar repeatability for every ordering code; use individual calibration and controlled mounting. HBK does not publish a separate scalar repeatability for every ordering code; use individual calibration and controlled mounting.
Sampling rate limited by system readout True True
Number of measurement channels 1 1
Number of axes 1 1
Static (DC) acceleration measurement False False
Sampling rate reference Sensor bandwidth is indexed by HBK; the selected conditioner and DAQ determine digital sample rate. Sensor bandwidth is indexed by HBK; the selected conditioner and DAQ determine digital sample rate.
Technical specification details ±6000 g indexed capacity; Uniaxial; General purpose; Stud mounting ±6000 g indexed capacity; Uniaxial; General purpose; Stud mounting
Vibration sensor output Piezoelectric charge; Analogue Piezoelectric charge; Analogue
Acceleration sensitivity 9.8 mV/g 9.8 mV/g
Linearity reference Official indexed sensitivity tolerance: 2%. Official indexed sensitivity tolerance: 15%.
Frequency response 0–16000 kHz 0–16000 kHz
Outputs and interfaces Unknown Unknown
Operating temperature -74–288 °C -74–288 °C
Status Active Active

The industries we serve

Frequently asked questions

Answers to the most common questions about our products and services

HBK lists 0.1 Hz to 12.6 kHz. The usable system bandwidth also depends on mounting and the readout chain.

The nominal sensitivity is 9.8 pC/g. Use the individual sensor’s calibration value when setting up the measurement channel.

The connector is on the side. Allow clearance for the connector and route the cable so it does not load the sensor.

The sensor provides a charge signal. Use a direct charge input or a compatible charge amplifier with a range suitable for the expected acceleration.

HBK positions it for vibration measurements that include higher frequencies. Check that the test frequencies and connector clearance suit the installation.

Didn't find the answer you were looking for?

Talk to an expert

More information

Get a quote or advice

Tell us what you need and an engineer will come back to you.

Request a quote for this product
What would you like to ask for?

Email or phone — one of them is enough

Email or phone — one of them is enough

0 of 500 words