Skip to content

TYPE 4374

Type 4374 suits tight spaces and light components whose dynamic response can change under the weight of a larger transducer. Its flat base is designed for adhesive mounting and the integral cable exits to the side. Nominal charge sensitivity differs between 4374 and 4374-L.

Visit the HBK site (opens in a new tab)

Shared technical specifications for the series

Properties every model in the series has. What differs is in the models table below.

Range across models

The span covered by the models of the series together — not the range of each model.

Range across the models of TYPE 4374
Acceleration sensitivity 1.08–1.47 mV/g

Models in the series

One column per model: what differs between the models of the series.

Models of TYPE 4374 compared by parameter
Parameter -4374— -4374--- -4374-L– -4374-L--
Operating temperature -74–288 °C -74–288 °C
Sampling rate limited by system readout True True
Frequency response 0.64–2700 Hz 0.64–2700 Hz
Repeatability reference HBK does not publish a separate scalar repeatability for every ordering code; use individual calibration and controlled mounting. HBK does not publish a separate scalar repeatability for every ordering code; use individual calibration and controlled mounting.
Technical specification details ±5000 g indexed capacity; Uniaxial; Miniature/ESS; Adhesive mounting ±5000 g indexed capacity; Uniaxial; Miniature/ESS; Adhesive mounting
Outputs and interfaces Unknown Unknown
Sampling rate reference Sensor bandwidth is indexed by HBK; the selected conditioner and DAQ determine digital sample rate. Sensor bandwidth is indexed by HBK; the selected conditioner and DAQ determine digital sample rate.
Vibration sensor output Piezoelectric charge; Analogue Piezoelectric charge; Analogue
Acceleration sensitivity 1.47 mV/g 1.08 mV/g
Number of axes 1 1
Number of measurement channels 1 1
Static (DC) acceleration measurement False False
Linearity reference Official indexed sensitivity tolerance: 20%. Official indexed sensitivity tolerance: 15%.
Status Active Active

The industries we serve

Frequently asked questions

Answers to the most common questions about our products and services

Datasheet BP 2038 and the manufacturer catalog specify 1 Hz to 26 kHz at the ±10% amplitude limit. Verify that the adhesive mounting and acquisition chain support the required test band.

Nominal charge sensitivity is 1.47 pC/g for 4374 and 1.08 pC/g for 4374-L. Use the unit’s calibrated sensitivity as the acquisition conversion factor.

The sensor weighs 0.75 g without the cable. Added mass can shift the natural frequencies of a light part, so account for the adhesive and any force that the cable applies.

Bond the flat base using an adhesive suited to the test surface and conditions. Route the side cable so its tension does not load the measurement point.

The integral cable ends in a 10–32 UNF connector. For extensions, use a low-noise coaxial cable and adapter suitable for charge measurements.

Didn't find the answer you were looking for?

Talk to an expert

More information

Get a quote or advice

Tell us what you need and an engineer will come back to you.

Request a quote for this product
What would you like to ask for?

Email or phone — one of them is enough

Email or phone — one of them is enough

0 of 500 words