Skip to content

TYPE 4397-A

Type 4397-A is designed for shock and vibration measurements on lightweight parts. Its built-in preamplifier delivers a voltage signal on the same line that supplies constant current. The sensor uses an M3 mounting stud and requires a cable that fits its side connector.

This series on the HBK site (opens in a new tab)

Models in the series

One column per model: what differs between the models of the series.

Models of TYPE 4397-A compared by parameter
Parameter -4397-A– -4397-A--
Outputs and interfaces Unknown
Frequency response 0.64–60000000 Hz
Number of measurement channels 1
Number of axes 1
Acceleration sensitivity 3.1 mV/g
Technical specification details ±500 g indexed capacity; Uniaxial; Miniature/ESS; Stud mounting
Operating temperature -50–150 °C
Status Active

The industries we serve

Frequently asked questions

Answers to the most common questions about our products and services

The sensor uses IEPE-compatible, constant-current CCLD excitation. The datasheet lists 2–10 mA, extending to 20 mA below 100°C, with 24–30 V unloaded supply voltage.

The datasheet lists 1 Hz to 25 kHz for ±10% and 1 Hz to 10 kHz for ±5%. Check the phase-response band separately when measuring phase.

Nominal sensitivity is 9.8 mV/g at the reference conditions of 159.2 Hz and 4 mA supply current. Configure the channel using the actual sensor calibration.

4397-A is supplied without a cable. Choose a cable that fits the sensor’s M3 side connector and the acquisition system input.

The sensor drawing recommends 18 mm of plug clearance. The separate mechanical mounting uses an M3 stud at the base.

Didn't find the answer you were looking for?

Talk to an expert

More information

Get a quote or advice

Tell us what you need and an engineer will come back to you.

Request a quote for this product
What would you like to ask for?

Email or phone — one of them is enough

Email or phone — one of them is enough

0 of 500 words