Skip to content

eddyNCDT DT3020 controller Inductive (eddy current)

eddyNCDT DT3020 controller: measurement controllers by Micro-Epsilon for inductive (eddy current).

Visit the Micro-Epsilon site (opens in a new tab)

Models in the series

One column per model: what differs between the models of the series.

Models of eddyNCDT DT3020 controller compared by parameter
Parameter DT3020
Protection class (DIN EN 60529) IP67
Operating temperature -20–105 °C
Resolution (% FSO) 0.004 %
Linearity (% FSO) < ±0.2 % FSO; matched sensor/controller, 3-/5-point linearization
Frequency response 10–5000 Hz
Interfaces RS-485
Dimension (drawing reference) 53 mm
Measuring rate, analog output 80 kHz
Measuring rate, digital interface 10 kHz
Static resolution (% FSO) 0.004 % FSO (RMS; reference: midrange; 20 Hz)
Dynamic resolution (% FSO) 0.01 % FSO (RMS; reference: midrange; 5 kHz)
Frequency response cutoff Maximum rate with a compatible controller 5 kHz
Channels 1
Interfaces via separate adapter usb / ethernet / ethercat / profinet / ethernet_ip
Supply voltage 12 V / 32 V
Storage temperature -20 °C / 105 °C
Temperature compensation 10 °C / 105 °C
Controller temperature stability (% FSO/K) < 0.025 % FSO/K (midrange; compensated temperature range)
Maximum current-output load 500 Ω
Switching output modes NPN / PNP / push-pull
Number of characteristic curves 1
Weight approx. 190 g
ADC sampling rate 80000 samples/s
Status Active
Datasheet PDF — DT3020 (opens in a new tab)

The industries we serve

Frequently asked questions

Answers to the most common questions about our products and services

Digital update is 10 kHz and analog update 80 kHz. Frequency response is adjustable up to 5 kHz; update rate is not bandwidth.

The <±0.2% FSO specification requires three-point linearization. Match linearization to the head, target material and installation.

No. Specifications distinguish 0.004% FSO at 20 Hz from 0.01% FSO at 5 kHz. Use the appropriate filter and dynamic conditions.

Controller operation is −20 to 105°C. Heads are selected separately; up to 200°C applies to particular heads, not every complete system.

RS485 is onboard. USB, Ethernet and industrial protocols need the appropriate interface module, plus matching power/signal and sensor cables.

Didn't find the answer you were looking for?

Talk to an expert

More information

Get a quote or advice

Tell us what you need and an engineer will come back to you.

Request a quote for this product
What would you like to ask for?

Email or phone — one of them is enough

Email or phone — one of them is enough

0 of 500 words